"You get what you pay for...it’s as simple as that. They are not the cheapest but they did an amazing job in just a little over a week, using superior materials and paint than the competition. They have crews on staff that are the best at what they do and it shows. Renfari and JR were incredibly responsive and easy to work with, answering all my questions and concerns quickly and thoroughly. They went out of their way to find and correct peripheral issues, like a leaky outdoor water spigot of which we were unaware. Because they fully back their product, they are going to go out of their way to make sure you get a beautiful 100% complete solution. It was a worry free experience that I
The thick canvas stays in place, so you don’t need to tape it, and you can use it to cover any surface. Plastic drop cloths are slippery to walk on or set a ladder on and don’t stay in place. Even worse, paint spills on plastic stay wet, and they can end up on your shoes and get tracked through the house.  Canvas is slippery on hard floors, so rosin paper is better over vinyl, tile and hardwood. Tape the sheets together and to the floor to provide a nonslip surface.

The frequency of your exterior repainting depends on several factors, including where you live, what your house is made out of, and what it was painted with. In North Texas, we’re protected from the salt sprays our coastal friends down south must consider. Even still, strong sunshine and excessive heat during the summer can take a serious toll on the life of your paint. Dark, oil-based paints may fade especially quickly. The paint may blister, too, or form bubbles on the surface. So there’s no concrete answer for how often to repaint your home — but if you start to see chips, cracks, bleaching, blistering, or any other issue that takes away from the appearance of your home, it’s time to consider repainting.

When the primer is dry, caulk all small joints (less than ¼-inch-wide) in the siding and trim. Most pros use siliconized acrylics—paint won't stick to straight silicones—but Guertin and O'Neil like the new, more expensive urethane acrylics for their greater flexibility and longevity. O'Neil stresses that it's shortsighted to skimp on caulk. "If the joint fails, you're back to square one." Guertin uses the lifetime rating as his quality guide. "I don't expect 35-year caulk will last 35 years, but it should last longer than a 15-year caulk."

Location: Arlington, TX Date: 04/06/2021 Number of Rooms: 1 - 2 What is the total square footage of the rooms to be painted?: Under 1500 sqft Which rooms need to be painted? (Check all that apply): Bathroom(s), Other What is the average ceiling height of the rooms you want painted?: 9 ft What needs to be painted? (Check all that apply): Ceiling, Wall, Trim What is the occupancy of the house?: Furnished and occupied Which best describes the condition of your walls?: Good - Has minor cosmetic defects that may require patching Request Stage: Ready to Hire Are you in the process of moving into or out of this home?: No Desired Completion Date: 1 - 2 weeks What kind of location is this?: Home/Residence
For a more skilled do-it-yourselfer, either flat or satin paint is suitable. If you are hiring a professional painter, choose the paint finish based only on results, not ease of application. Professional painters are proficient at applying all types of paints and paint finishes. If they make an error, they are accountable and can be expected to fix the issue. 
If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer.
When painting outside, it is always best to check the tin for the minimum/maximum temperatures. You must also take into account chill factors, especially on metal, as this can reduce surface temperatures considerably. From a health and safety perspective, there isn't a specific minimum or maximum temperature for a worker to paint in. Dress appropriately and stay ventilated/hydrated.
Location: Arlington, TX Date: 04/06/2021 Number of Rooms: 3 - 4 What is the total square footage of the rooms to be painted?: Under 1500 sqft Which rooms need to be painted? (Check all that apply): Kitchen, Living Areas, Hallways What is the average ceiling height of the rooms you want painted?: 8 ft What needs to be painted? (Check all that apply): Wall What is the occupancy of the house?: Furnished and occupied Which best describes the condition of your walls?: Very Good - Looks new and requires no repairs Request Stage: Ready to Hire Are you in the process of moving into or out of this home?: No Desired Completion Date: Timing is flexible What kind of location is this?: Home/Residence Historical Work: No Comment: These are NOT large projects Small kitchen wall Living room standard size Hallway standard size

After a while, painted houses start to reveal wear and tear, so once in a while, doing a refreshing exterior house-painting project can bring back your home’s vibrancy. There is a lot of preparation work required for repainting a house but it's important to not skip this part because it makes the painting work much easier and ensures that the paintwork endures and stays in great condition.
Follow the shade. When you are painting the exterior of your home, you would be wise to follow the shade from your house and avoid the sun. As the sun moves around your house, try to avoid the sun as much as possible because you may become overheated with the sun beating down on you, and painting in direct sunlight (depending on the heat of the day) is not good for the application process and can cause bubbling/adhesion issues. By moving with the shade, you minimize these potential problems.
With Harrington Home Painting, you know what to expect every step of the way. Gather as much information as possible for your first Harrington Home Painting consultation. We have a professional team that can create a plan to fit your project needs, style and budget. We aim to make the painting experience as comfortable as possible, with no unexpected costs or delays.
Caulk and seal any windows or openings to prevent air and water from leaking in. This may be the most important part of the prepping process. It's important to have a well-maintained, beautified, non-rotting wood house, but it's just as important to make sure that the windows, cracks and openings aren't leaking air or letting in water, which can ruin the interior of your house. Depending on the severity of the deterioration, you can even resort to using a heavy duty, professional grade, industrial caulking.[6]
Painting the enterior of your own house is fun. Especially when you're doing it with other family members together. But it's also important to follow the standard methods to ensure quality painting with soothing aesthetics. Our painting and remodeling crew from Arlington, TX can insure the basic rules of enterior painting are followed and make sure your house not only looks better but will last for years to come. Following are some basic principals to follow should you decide to tackle the job on your own.
Location: Arlington, TX Date: 04/07/2021 What is the approximate living square footage of your home?: 1500-3000 sqft What is the primary exterior surface material of your home?: Brick How many stories is your home?: One story What size is your attached garage?: 2-Car Garage Which best describes the condition of your walls?: Good - Has minor cosmetic defects that may require patching Request Stage: Planning & Budgeting Desired Completion Date: More than 2 weeks
If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer.
×