Caulk and seal any windows or openings to prevent air and water from leaking in. This may be the most important part of the prepping process. It's important to have a well-maintained, beautified, non-rotting wood house, but it's just as important to make sure that the windows, cracks and openings aren't leaking air or letting in water, which can ruin the interior of your house. Depending on the severity of the deterioration, you can even resort to using a heavy duty, professional grade, industrial caulking.[6]
The frequency of your exterior repainting depends on several factors, including where you live, what your house is made out of, and what it was painted with. In North Texas, we’re protected from the salt sprays our coastal friends down south must consider. Even still, strong sunshine and excessive heat during the summer can take a serious toll on the life of your paint. Dark, oil-based paints may fade especially quickly. The paint may blister, too, or form bubbles on the surface. So there’s no concrete answer for how often to repaint your home — but if you start to see chips, cracks, bleaching, blistering, or any other issue that takes away from the appearance of your home, it’s time to consider repainting.
Follow the shade. When you are painting the exterior of your home, you would be wise to follow the shade from your house and avoid the sun. As the sun moves around your house, try to avoid the sun as much as possible because you may become overheated with the sun beating down on you, and painting in direct sunlight (depending on the heat of the day) is not good for the application process and can cause bubbling/adhesion issues. By moving with the shade, you minimize these potential problems.
From helping you choose the best colors to meticulously prepping your walls and applying paint with an expert hand, Southern Painting has all your interior painting needs covered. Plus, at the end of each work day, we will clean up and remove all supplies, tools, and trash. We will also put the furniture back where it belongs, rehang shades and blinds, and replace all switch plates and outlet covers. When we leave, your room will be ready for you to enjoy!
When painting outside, it is always best to check the tin for the minimum/maximum temperatures. You must also take into account chill factors, especially on metal, as this can reduce surface temperatures considerably. From a health and safety perspective, there isn't a specific minimum or maximum temperature for a worker to paint in. Dress appropriately and stay ventilated/hydrated.
We take great pride in our experience, expertise, quality, and customer service that we provide to meet the consumer’s needs. It is our mission to provide excellent workmanship and complete customer satisfaction from start to completion of a project. In order to understand the needs and expectations of our customers, we take great care to work and communicate with every customer in a professional manner. Our reputation is based on service, safety, and quality, regardless of how large or small the job.
Licensed, certified, insured, bonded, and working at reasonable rates, Snug Harbor Service has been in business since 2016 and is accredited by the Better Business Bureau. We also provide free estimates on our labor and discounts to new customers, senior citizens, disabled people, and veterans. Choose our commercial and home improvement company! We will exceed your expectations.
It is possible for your house painting project to be done right the first time without hidden charges, hassles or poor quality that are commonly found in painting. If you are interested in a project to paint a room, interior painting of your home, exterior painting of your home, or applying a special paint finish to your walls or ceilings, my team has the experience you would expect.
If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer.

O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer.
#3 Plastic sheets are the most popular items for protecting shrubs and windows as well as other structures while the painting job is on. But you should think about a onetime investment to keep things economic, simple and more effective. You should choose canvas instead of plastic sheets. They will serve you longer and do a better job of protection. They will also provide with better safety.
After a while, painted houses start to reveal wear and tear, so once in a while, doing a refreshing exterior house-painting project can bring back your home’s vibrancy. There is a lot of preparation work required for repainting a house but it's important to not skip this part because it makes the painting work much easier and ensures that the paintwork endures and stays in great condition.
Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches.
×